H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches Chapter 3 RIP Configuration
3-4
To do... Use the command... Remarks
Enter system view
system-view
—
Enable RIP globally and
enter RIP view
rip
—
Enable RIP on the
interface of a specified
network segment
network network-address
Required
By default, RIP is disabled
on any interface.
 Note:
z If you make some RIP configurations in interface view before enabling RIP, those
configurations will take effect after RIP is enabled.
z RIP runs only on the interfaces residing on the specified networks. Therefore, you
need specify the network after enabling RIP to validate RIP on a specific interface.
II. Set the RIP operating status on an interface
Follow these steps to set the RIP operating status on an interface:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
—
Enable an interface to receive
RIP routing updates
rip input
Enable the interface to send
RIP routing updates
rip output
Enable the interface to send
and receive RIP packets
rip work
Optional
By default, all the
interfaces are
allowed to send
and receive RIP
packets.
III. Specify the RIP version on an interface
Follow these steps to specify the RIP version on an interface:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
—