H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches Chapter 3 RIP Configuration
3-8
 Note:
z The filter-policy import command filters the RIP routes received from neighbors,
and the routes being filtered out will neither be added to the routing table nor be
advertised to any neighbors.
z The filter-policy export command filters all the routes to be advertised, including
the routes imported by using the import-route command as well as RIP routes
learnt from neighbors.
z The filter-policy export command without the routing-protocol argument filters all
the routes to be advertised, including the routes imported by the import-route
command.
V. Set RIP preference
Follow these steps to set RIP preference:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter RIP view
rip
—
Set the RIP
preference
preference value
Required
The default RIP preference is 100.
VI. Enable RIP traffic sharing
Follow these steps to enable RIP traffic sharing:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter RIP view
rip
—
Enable traffic
sharing
traffic-share-across-int
erface
Required
By default,
traffic-share-across-interface is
disabled
VII. Configure RIP route redistribution
Follow these steps to configure RIP route redistribution:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter RIP view
rip
—