H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches Chapter 3 RIP Configuration
3-10
To do... Use the command... Remarks
Enter system view
system-view
—
Enter RIP view
rip
—
Set the values of RIP
timers
timers { update
update-timer | timeout
timeout-timer } *
Required
By default, Update timer value
is 30 seconds and Timeout
timer value is 180 seconds.
 Note:
When configuring the values of RIP timers, you should take network performance into
consideration and perform consistent configuration on all routers running RIP to avoid
unnecessary network traffic and network route oscillation.
II. Configure split horizon
Follow these steps to configure split horizon:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter interface view
interface
interface-type
interface-number
—
Enable split horizon
rip split-horizon
Required
By default, an interface uses split
horizon to send RIP packets.
 Note:
Disabling the split horizon function on a point-to-point link does not take effect.
III. Configure RIP-1 packet zero field check
Follow these steps to configure RIP-1 packet zero field check:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter RIP view
rip
—