H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches Chapter 3 RIP Configuration
3-12
To do... Use the command... Remarks
Enter system view
system-view
—
Enter RIP view
rip
—
Configure a RIP
neighbor
peer ip-address
Required
To make RIP works on a link that
does not support broadcast/multicast
packets, you must manually configure
the RIP neighbor.
Normally, RIP uses broadcast or
multicast addresses to send packets.
3.6 Displaying and Maintaining RIP Configuration
To do... Use the command... Remarks
Display the current RIP running status
and configuration information
display rip
Display RIP routing information
display rip routing
Available in any
view
Reset the system configuration
related to RIP
reset
Available in RIP
view
3.7 RIP Configuration Example
I. Network requirements
As shown in Figure 3-1, Switch C is connected to subnet 117.102.0.0 through an
Ethernet port. Switch A and Switch B are connected to networks 155.10.1.0 and
196.38.165.0 respectively through Ethernet ports. Switch C, Switch A and Switch B
are interconnected through Ethernet 110.11.2.0. It is required to configure RIP
correctly to ensure the interworking between the networks connected to Switch C,
Switch A and Switch B.