H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches Chapter 4 OSPF Configuration
4-9
Task Remarks
Configuring the Network Type of an
OSPF Interface
Optional
Setting an NBMA Neighbor Optional
OSPF Network Type
Configuration
Setting the DR Priority on an OSPF
Interface
Optional
Configuring OSPF Route Summary Optional
Configuring OSPF to Filter Received
Routes
Optional
Configuring the Cost for Sending
Packets on an OSPF Interface
Optional
Setting OSPF Route Priority Optional
OSPF Route Control
Configuring OSPF to Redistribute
Routes
Optional
Configuring OSPF Timers Optional
Configuring the LSA transmission
delay
Optional
Configuring the SPF Calculation
Interval
Optional
Disabling OSPF Packet Transmission
on an Interface
Optional
Configuring OSPF Authentication Optional
Configuring to Fill the MTU Field
When an Interface Transmits DD
Packets
Optional
OSPF Network
Adjustment and
Optimization
Configuring OSPF Network
Management System (NMS)
Optional
4.3 Basic OSPF Configuration
Before you can configure other OSPF features, you must first enable OSPF and
specify the interface and area ID.
4.3.1 Configuration Prerequisites
Before configuring OSPF, perform the following tasks:
z Configuring the link layer protocol
z Configuring the network layer addresses of interfaces so that adjacent nodes are
reachable to each other at the network layer