H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches Chapter 6 BGP Configuration
6-7
Task Remarks
Configuring Basic BGP Functions Required
Importing Routes Optional
Configuring BGP Route Aggregation Optional
Enabling Default Route Advertising Optional
Configuring the BGP Route Advertising
Policy
Optional
Configuring BGP Route Receiving Policy Optional
Configuring BGP-IGP Route
Synchronization
Optional
Configuring BGP Route Dampening Optional
Configuring the
Way to
Advertise/Rece
ive Routing
Information
Configuring BGP Load Balance Required
Configuring BGP Route Attributes Optional
Adjusting and Optimizing a BGP Network Optional
Configuring a BGP Peer Group Required
Configuring a BGP Community Required
Configuring BGP RR Optional
Configuring a
Large-Scale
BGP Network
Configuring BGP Confederation Optional
6.3 Basic BGP Configuration
6.3.1 Configuration Prerequisites
Before performing basic BGP configuration, you need to ensure:
z Network layer connectivity between adjacent nodes.
Before performing basic BGP configuration, make sure the following are available.
z Local AS number and router ID
z IPv4 address and AS number of the peers
z Source interface of update packets.
6.3.2 Configuring Basic BGP Functions
Follow these steps to configure basic BGP functions:
To do... Use the command... Remarks
Enter system view
system-view
—
Specify the router ID
router id router-id
Optional