H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Routing Protocol
H3C S7500 Series Ethernet Switches Chapter 8 Route Capacity Configuration
8-2
connection. If the automatic protocol connection recovery function is disabled, the
switch will not re-establish the disconnected IS-IS, BGP or OSPF connection even
when the free memory restores to a value larger than the safety value.
8.2 Route Capacity Configuration
Route capacity configuration includes:
z Setting the lower limit and the safety value of switch memory
z Enabling/disabling the switch to recover the disconnected routing protocol
automatically
8.2.1 Setting the Lower Limit and the Safety Value of the Switch Memory
Follow these steps to set the lower limit and the safety value of switch memory:
To do... Use the command... Remarks
Enter system view
system-view
—
Set the lower limit and the
safety value of switch memory
memory { safety safety-value |
limit limit-value }*
Optional
 Note:
The safety-value must be greater than the limit-value.
8.2.2 Enabling/Disabling Automatic Protocol Connection Recovery
Follow these steps to enable/disable automatic protocol recovery:
To do... Use the command... Remarks
Enter system view
system-view
—
Enable automatic protocol
recovery
memory auto-establish
enable
Optional
By default, automatic
protocol connection
recovery is enabled.
Disable automatic
protocol connection
recovery
memory auto-establish
disable
Optional