H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Login
H3C S7500 Series Ethernet Switches Chapter 2
Logging in through the Console Port
2-6
2.4 Console Port Login Configuration with Authentication
Mode Being None
2.4.1 Configuration Procedure
Follow these steps to perform the console port login configuration with the
authentication mode being none:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter AUX user interface view user-interface aux 0 —
Configure not to authenticate
users
authentication-mode
none
Required
By default, users
logging in through the
console port need not
to be authenticated.
Set the baud
rate
speed speed-value
Optional
The default baud rate of
an AUX port (also the
console port) is 9,600
bps.
Set the check
mode
parity { even | mark |
none | odd | space }
Optional
By default, the check
mode of a console port
is set to none, that is,
no check bit.
Set the flow
control mode
flow-control
{ hardware | none |
software }
Optional
By default, a console
port does not perform
flow control.
Set the stop
bits
stopbits { 1 | 1.5 | 2 }
Optional
The stop bits of a
console port is 1.
Configure the
console port
Set the data
bits
databits { 7 | 8 }
Optional
The default data bits of
a console port is 8.
Configure the command level
available to users logging into
the user interface
user privilege level
level
Optional
By default, commands
of level 3 are available
to users logging into the
AUX user interface.
Make terminal services
available
shell
Optional
By default, terminal
services are available
in all user interfaces.