H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Multicast
H3C S7500 Series Ethernet Switches Chapter 7
PIM Configuration
7-14
Task Remarks
Configuring Filtering Policies for Multicast Source/Group Optional
Configuring BSR/RP Optional
Configuring PIM-SM Domain Boundary Optional
Configuring the RP to Filter Register Messages from the DR Optional
7.4.1 Configuring Filtering Policies for Multicast Source/Group
For the configuration of filtering policies for multicast source/group, refer to Configuring
Filtering Policies for Multicast Source/Group
.
7.4.2 Configuring BSR/RP
Follow these steps to configure BSR/RP:
To do... Use the command... Remarks
Enter system view system-view —
Enable the multicast
routing protocol
multicast
routing-enable
Required
Enter PIM view
pim —
Configure candidate
BSRs
c-bsr interface-type
interface-number
hash-mask-len [ priority ]
Optional
By default, candidate BSRs are
not set for the switch and the
value of priority is 0.
Configure candidate
RPs
c-rp interface-type
interface-number
[ group-policy
acl-number | priority
priority ]*
Optional
z You can configure to filter the
IP addresses of some
multicast groups in an ACL.
z By default, candidate RPs are
not set for the switch and the
value of priority is 0.
Configure static RPs
static-rp rp-address
[ acl-number ]
Optional
z You can configure to filter the
IP addresses of some
multicast groups in ACL.
z By default, static RPs are not
set for the switch.
Limit the range of
valid BSRs
bsr-policy acl-number
Optional
z You can configure to filter the
IP addresses of some
multicast groups in an ACL.
z By default, the range of valid
BSRs is not set for the switch.