H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – 802.1x
H3C S7500 Series Ethernet Switches
Chapter 1 802.1x Configuration
1-18
Table 1-5 Enable DHCP-triggered authentication
To do... Use the command... Remarks
Enter system view
system-view
—
Enable DHCP-triggered
authentication
dot1x dhcp-launch
Disabled by default
1.5.5 Configuring Guest VLAN
Table 1-6 Configure Guest VLAN
To do... Use the command... Remarks
Enter system view
system-view
—
Configure control access
method
dot1x port-method
{ macbased |
portbased }
Optional
macbased method by
default
Enable the Guest VLAN
function
dot1x guest-vlan vlan-id
[ interface interface-list ]
Required
Disabled by default
Caution:
z The Guest VLAN function is available only when the switch operates in a port-based
authentication mode.
z Only one Guest VLAN can be configured for each switch.
1.6 Displaying and Debugging 802.1x
After performing the above configurations, you can display and verify the
802.1x-related configuration by executing the display command in any view.
You can clear 802.1x-related statistics by executing the reset command in user view.