H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – 802.1x
H3C S7500 Series Ethernet Switches
Chapter 2 HABP Configuration
2-2
To do... Use the command... Remarks
Configure the
current switch to be
an HABP server
habp server vlan
vlan-id
Required
By default, a switch operates as
an HABP client after you enable
HABP on the switch, and if you
want to use the switch as a
management switch, you must
configure the switch to be an
HABP server.
Configure the
interval to send
HABP request
packets
habp timer interval
Optional
20 seconds by default
2.3 HABP Client Configuration
HABP clients reside on the switches attached to the HABP server. After you enable
HABP on a switch, the switch operates as an HABP client by default. So you only need
to enable HABP on a switch.
Table 2-2 Configure an HABP client
To do... Use the command... Remarks
Enter system view
system-view
—
Enable HABP
habp enable
Optional
Enabled by default
A switch operates as an HABP client
after you enable HABP on it.
2.4 Displaying HABP
After performing the above configuration, you can display and verify HABP
configuration by executing the display command in any view.
Table 2-3 Display HABP
To do... Use the command... Remarks
Display information about HABP
configuration and status
display habp
Display information about the MAC
address table maintained by HABP
display habp table
Display statistics of HABP packets
display habp traffic
In any view