H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – QoS
H3C S7500 Series Ethernet Switches Chapter 1
QoS Configuration
1-20
To do… Use the command… Remarks
Enter QoS view
qos
—
Configure port-based
rate limiting
line-rate [ kbps ] target-rate Required
 Note:
Only non-type-A LPUs support port-based rate limiting.
1.6.3 Configuration Example
z Configure rate limiting on GigabitEthernet 2/0/1 of the switch
z Limit the rate to 10 Mbps.
Configuration procedure:
<H3C> system-view
[H3C] interface GigabitEthernet2/0/1
[H3C-GigabitEthernet2/0/1] qos
[H3C-qosb-GigabitEthernet2/0/1] line-rate 10
1.7 Configuring TP
Refer to TP for information about TP.
1.7.1 Configuration Prerequisites
z ACL rules used for traffic identifying are defined. Refer to the ACL module in this
manual for defining ACL rules.
z The limit rate for TP, the actions for the packets within the specified traffic
specification and the actions for the packets beyond the specified traffic
specification have been specified.
z The ports that need this configuration are specified.
1.7.2 Configuration Procedure of TP
Follow these steps to configure TP:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
—
Enter QoS view
qos
—