H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – QoS
H3C S7500 Series Ethernet Switches Chapter 1
QoS Configuration
1-22
[H3C-GigabitEthernet2/0/1] qos
[H3C-qosb-GigabitEthernet2/0/1] traffic-limit inbound ip-group 2000 kbps 128
exceed remark-dscp 56
1.8 Configuring Redirect
Refer to Redirect for the introduction to redirect.
1.8.1 Configuration Prerequisites
z ACL rules used for traffic identifying are defined. Refer to the ACL module in this
manual for defining ACL rules.
z The port that the packets are to be redirected to is specified.
z The ports that need this configuration are specified.
1.8.2 Configuration Procedure
Follow these steps to configure redirect:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
—
Enter QoS view
qos
—
Configure redirect
traffic-redirect inbound acl-rule
[ system-index ] { cpu | interface
interface-type interface-number }
Required
Display the
parameters for traffic
redirect
display qos-interface
[ interface-type interface-number ]
traffic-redirect
Display all the QoS
settings of the port
display qos-interface
[ interface-type interface-number ]
all
Optional
You can execute the
display command in
any view.
acl-rule: Applied ACL rules which can be the combination of various ACL rules. The
way of combination is described in
Table 1-10.