H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – QoS
H3C S7500 Series Ethernet Switches Chapter 1
QoS Configuration
1-23
 Note:
z Only non-type-A LPUs support the traffic redirect configuration.
z In a traffic redirect configuration, the source port and the destination port must be on
the same LPU.
z The redirect configuration is effective only for ACL rules defined with the permit
keyword specified.
z When packets are redirected to the CPU, they cannot be forwarded normally.
1.8.3 Configuration Example
z A switch is connected to 10.1.1.1/24 network segment through its Ethernet 2/0/1
port.
z Redirect all the traffic from the 10.1.1.1/24 network segment to GigabitEthernet
2/0/7.
Configuration procedure:
<H3C> system-view
[H3C] acl number 2000
[H3C-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[H3C-acl-basic-2000] quit
[H3C] interface GigabitEthernet2/0/1
[H3C-GigabitEthernet2/0/1] qos
[H3C-qosb-GigabitEthernet2/0/1] traffic-redirect inbound ip-group 2000
interface GigabitEthernet 2/0/7
1.9 Configuring Queue Scheduling
Refer to Queue Scheduling for the introduction to queue scheduling.
1.9.1 Configuration Prerequisites
z The queue-scheduling algorithm is specified.
z The ports that need this configuration are specified.
1.9.2 Configuration Procedure
Follow these steps to configure queue scheduling:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
—