H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – QoS
H3C S7500 Series Ethernet Switches Chapter 1
QoS Configuration
1-27
[H3C] interface Ethernet2/0/1
[H3C-Ethernet2/0/1] qos
[H3C-qoss-Ethernet2/0/1] traffic-red outbound ip-group 2000 64 128 20
1.11 Configuring Traffic Statistics
Refer to Traffic-based Traffic Statistics for the introduction to traffic statistics.
1.11.1 Configuration Prerequisites
z ACL rules used for traffic identifying are defined. Refer to the ACL module in the
book for defining ACL rules.
z The ports that need this configuration are specified.
1.11.2 Configuration Procedure of Traffic Statistics
Follow these steps to configure traffic statistics:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Enter QoS view
qos
—
traffic-statistic
{ inbound | outbound }
acl-rule [ system-index ]
Required
Type A LPUs support this
command.
Use the ACL rules in
traffic identifying and
perform traffic statistics on
the packets matching the
ACL rules
traffic-statistic inbound
acl-rule [ system-index ]
Required
Non-type-A LPUs support
this command.
Display the traffic
statistics
display qos-interface
[ interface-type
interface-number ]
Display all the QoS
settings of the port
display qos-interface
[ interface-type
interface-number ] all
Optional
You can execute the
display command in any
view.
acl-rule: Applied ACL rules which can be the combination of various ACL rules. Type-A
LPUs’ way of combination is described in
Table 1-9, and non-type-A LPUs’ way of
combination is described in
Table 1-10.
1.11.3 Clearing Traffic Statistics Information
Follow these steps to clear traffic statistics information: