H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – QoS
H3C S7500 Series Ethernet Switches Chapter 1
QoS Configuration
1-31
 Note:
The inboundcar command is applicable to A-type LPUs only and can only take effect
after the switch is restarted.
1.13.2 Configuration Procedure
# Enable the inbound CAR feature.
<H3C> system-view
[H3C] inboundcar enable
1.14 Configuring Traffic-Based Selective QinQ
QinQ is to encapsulate the VLAN tags of the private network in the VLAN tags of the
public network in order that the frames are transmitted through the backbone network
of the service provider network (also called public network). The traffic-based selective
QinQ feature can tag a frame with an outer VLAN tag according to the ACL rule that the
frame matches on the inbound port.
The traffic-based selective QinQ feature is usually configured on the hybrid port of the
edge device connecting the user device to the service provider network.
1.14.1 Configuration Prerequisites
z ACL rules used for traffic identifying are defined. Refer to the ACL module in this
manual for defining ACL rules.
z ID of the outer VLAN tag is specified.
z The ports that needs this configuration are specified
1.14.2 Configuration Procedure
Follow these steps to configure the traffic-based selective QinQ feature:
To do… Use the command… Remarks
Enter system view
system-view
—
Create a VLAN
vlan vlan-id
The vlan-id argument is
the ID of the outer VLAN
tag.
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the port as a
hybrid port
port link-type hybrid —