H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Mirroring
H3C S7500 Series Ethernet Switches Chapter 1
Mirroring Configuration
1-8
To do… Use the command… Remarks
Enter port view of ports
that connected to the
intermediate switch or
destination switch
interface interface-type
interface-number
—
Configure the current port
as a trunk port
port link-type trunk
Required
By default, the type of the
port is access.
Configure Trunk port to
permit packets from the
remote-probe VLAN
port trunk permit vlan
remote-probe-vlan-id
Required
This setting is required for
source switch ports that
connected with the
intermediate switch or
destination switch.
Exit current view
quit
—
Configure a remote
source mirroring group
mirroring-group group-id
remote-source
Required
Configure a source port
for remote mirroring
mirroring-group group-id
mirroring-port
mirroring-port-list { both |
inbound | outbound }
Required
Configure a remote
reflector port
mirroring-group group-id
reflector-port
reflector-port
Required
The remote reflector port
must be of the Access
type. LACP and STP must
be disabled on this port.
After a port is configured
as a reflector port, the
switch does not allow you
to perform any of the
following configurations:
z Changing the port type
and its default VLAN
ID
z Add it to another VLAN
Configure the
remote-probe VLAN for
the remote source
mirroring group
mirroring-group group-id
remote-probe vlan
remote-probe-vlan-id
Required
Display the configuration
of the remote source
mirroring group
display mirroring-group
remote-source
Optional
This command can be
executed in any view.