H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Mirroring
H3C S7500 Series Ethernet Switches Chapter 1
Mirroring Configuration
1-10
 Note:
When a switch acts as a remote port mirroring intermediate switch, to realize the data
mirroring successfully, you are recommended to configure redirection on the inbound
interface and redirect all the packets in the remote-probe VLAN to the corresponding
outbound interface.
IV. Configuring remote port mirroring on the destination switch
To do… Use the command… Remarks
Enter system view
system-view
—
Create a remote-probe
VLAN and enter VLAN
view
vlan vlan-id
vlan-id is the ID of the
remote-probe VLAN.
Define the current VLAN
as a remote-probe VLAN
remote-probe vlan
enable
Required
Exit the current view
quit
—
Enter Ethernet port view
of the port through which
the destination switch is
connected to the source
switch or an intermediate
switch
interface interface-type
interface-number
—
Configure the current port
as a trunk port
port link-type trunk
Required
By default, the type of the
port is access.
Configure Trunk port to
permit packets from the
remote-probe VLAN
port trunk permit vlan
remote-probe-vlan-id
Required
This configuration is
necessary for ports
through which the
destination switch is
connected to the source
switch or an intermediate
switch.
Exit current view
quit
—
Configure the remote
destination mirroring
group
mirroring-group group-id
remote-destination
Required