H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Mirroring
H3C S7500 Series Ethernet Switches Chapter 1
Mirroring Configuration
1-17
To do… Use the command… Remarks
Configure the remote
reflector port
mirroring-group
group-id reflector-port
reflector-port
Required
The remote reflector port
must be Access port and
LACP and STP must be
disabled on the remote
reflector port.
After a port is configured as
reflector port, you can
neither change the port
type and the default VLAN
ID nor add the reflector port
to other VLANs.
Configure the
remote-probe VLAN of
the remote source
mirroring group
mirroring-group
group-id remote-probe
vlan
remote-probe-vlan-id
Required
Ether Ethernet port view
of the source port
interface interface-type
interface-number
—
Enter QoS view
qos
—
Reference ACLs for
identifying traffic flows
and perform traffic
mirroring for packets that
match.
mirrored-to inbound
acl-rule [ system-index ]
{ interface interface-type
interface-number
reflector |
mirroring-group
group-id }
Required
Display configuration of
the remote source
mirroring group
display mirroring-group
remote-source
Display the parameter
settings of traffic
mirroring
display qos-interface
[ interface-type
interface-number ]
mirrored-to
Display all QoS settings
of a port
display qos-interface
[ interface-type
interface-number ] all
Optional
You can execute the
display command in any
view.
acl-rule: Applied ACL rules, which can be the combination of different types of ACL
rules. For the ACL combinations of the type A LPUs, refer to
Table 1-3, and for the ACL
combinations of LPUs other than type A, refer to
Table 1-4.