H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Cluster
H3C S7500 Series Ethernet Switches Chapter 1
Cluste
r
1-9
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the cluster
function globally
cluster enable
Optional
By default, the cluster function is
enabled
1.2.7 Configuring Cluster Parameters
I. Creating a cluster and configuring cluster parameters manually
Follow these steps to configure cluster parameters manually:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter VLAN interface view
interface Vlan-interface
vlan-id
Required
You are required to
configure the IP address
of the Layer 3 virtual
interface of VLAN 1
before you set up a
cluster. Otherwise, the
cluster cannot be set up.
Configure the IP address
of the VLAN interface
ip address ip-address
{ mask | mask-length }
Required
Enter cluster view
cluster
—
Configure an IP address
pool for the cluster
ip-pool
administrator-ip-address
{ ip-mask |
ip-mask-length }
Required
Build a cluster
build name
Optional
The name argument
indicates the name to be
assigned.
Configure the holdtime for
a switch
holdtime seconds
Optional
By default, the holdtime is
60 seconds
Set the interval to send
handshake packets
timer interval
Optional
By default, the interval to
send handshake packets
is 10 seconds
Quit cluster view
quit
—