H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Cluster
H3C S7500 Series Ethernet Switches Chapter 1
Cluste
r
1-13
To do… Use the command… Remarks
Switch between the
management device view
and a member device
view
cluster switch-to
{ member-number |
mac-address H-H-H |
administrator }
Optional
Switch between the
management device view
and the member device
view
1.5 Displaying and Maintaining a Cluster
To do… Use the command… Remarks
Display the global NDP
configuration (including the
interval to send NDP
packets and the holdtime)
display ndp
Display the information
about the neighbors
discovered by NDP and
connected to specified ports
display ndp interface port-list
Display the global NTDP
information
display ntdp
Display device information
collected through NTDP
display ntdp device-list
[ verbose ]
Display state and statistics
information about a cluster
display cluster
Display the information
about the candidate devices
of a cluster
display cluster candidates
[ mac-address H-H-H | verbose ]
Display the information
about the cluster members
display cluster members
[ member-number | verbose ]
Optional
Available in
any view
Clear the NDP statistics on
a port
reset ndp statistics [ interface
port-list ]
—
1.6 Cluster Configuration Example
1.6.1 Cluster Configuration Example
I. Network requirements
Three switches form a cluster, in which:
z The management device is an S7500 switch.
z The rest are member devices.