H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – SNMP and RMON
H3C S7500 Series Ethernet Switches Chapter 1
SNMP Configuration
1-3
Table 1-1 Common MIBs
MIB attribute MIB content References
MIB II based on TCP/IP network
devices
RFC1213
RFC1493
BRIDGE MIB
RFC2675
RIP MIB RFC1724
RMON MIB RFC2819
Ethernet MIB RFC2665
OSPF MIB RFC1253
Public MIB
IF MIB RFC1573
DHCP MIB —
QACL MIB —
ADBM MIB —
RSTP MIB —
VLAN MIB —
Device management —
Private MIB
Interface management —
1.2 Configuring SNMP Basic Functions
The configuration of SNMPv3 is different from that of SNMPv1 and SNMPv2c, so
SNMP basic function configurations for different versions are introduced respectively.
For specific configurations, refer to the following two tables.
Follow these steps to configure SNMP basic functions for SNMPv1 and SNMPv2c:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable SNMP agent
snmp-agent
Optional
By default, SNMP
agent is disabled
To enable SNMP
agent, you can
execute this
command or those
commands used to
configure SNMP
agent features