H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Login
H3C S7500 Series Ethernet Switches Chapter 4
Logging in Using Modem
4-5
Figure 4-3 Call the Modem
5) Provide the password on the emulation grogram when prompted. If the password
is correct, the prompt (such as <H3C>) appears. You can then configure or
manage the switch. You can also enter the character ? at anytime for help. Refer
to the following chapters for information about the configuration commands.
 Note:
If you perform no AUX user-related configuration on the switch, the commands of level
3 are available to Modem users. Refer to the CLI module for information about
command level.
4.5 Modem Attributes Configuration
You can configure the Modem-related parameters.
4.5.1 Configuration Prerequisites
z You have configured the login mode for users on the switch.
z Network connection for Modem dial-up configuration has been established.
4.5.2 Configuration Procedure
Follow these steps to configure Modem attributes: