H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Information Center
H3C S7500 Series Ethernet Switches Chapter 1
Information Cente
r
1-7
To do... Use the command... Remarks
Enable information output
to a log host
info-center loghost
host-ip-addr [ channel
{ channel-number |
channel-name } | facility
local-number | language
{ chinese | english } ]*
Required
By default, the switch
does not output
information to the log
host.
After you configure the
switch to output
information to the log
host, the switch uses
information channel 2 by
default.
Be sure to set the correct
IP address. A loopback IP
address will cause an
error message prompting
an invalid address.
Configure the source
interface through which
log information is sent to
the log host
info-center loghost
source interface-type
interface-number
Optional
Define an information
source
info-center source
{ modu-name | default }
channel
{ channel-number |
channel-name } [ { log |
trap | debug } * { level
severity | state state } ]*
Required
Set the format of the time
stamp
info-center timestamp
{ log | trap | debugging }
{ boot | date | none }
Optional
 Note:
To view the debugging information of specific modules, you need to set the information
type to debug in the info-center source command, and enable debugging for
corresponding modules through the debugging command.
1.2.2 Enabling Information Output to the Console
Follow these steps to enable information output to the console: