H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – Information Center
H3C S7500 Series Ethernet Switches Chapter 1
Information Cente
r
1-12
To do... Use the command... Remarks
Enable
information output
to the trap buffer
info-center trapbuffer
[channel { channel-number |
channel-name } | size
buffersize]*
Optional
By default, the switch uses
information channel 3 to
output trap information to the
trap buffer, which can holds
up to 256 items by default.
Define an
information
source
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
Required
Set the format of
time stamp
info-center timestamp { log |
trap | debugging } { boot |
date | none }
Optional
This is to set the time stamp
format for
log/debugging/trap
information output.
This determines the time
stamp viewable to users.
 Note:
To view debugging information of specific modules, you need to set the information
type to debug in the info-center source command, and enable debugging on
corresponding modules using the debugging command as well.
1.2.6 Enabling Information Output to the SNMP
Follow these steps to enable information output to the SNMP:
To do... Use the command... Remarks
Enter system view
system-view
—
Enable the
information center
info-center enable
Optional
By default, the information center is
enabled.
Enable
information output
to the SNMP
info-center snmp
channel
{ channel-number |
channel-name }
Required
By default, the switch outputs trap
information to SNMP through
channel 5.