H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches
Chapter 2 Basic System Configuration and
Debugging
2-5
1
2
3
ON
Protocol debugging switches
ON OFF
ONOFF
1
3
1
Debugging information
1
2
3
Terminal display switches
1
3
ON
Protocol debugging switches
ON OFF
ONOFF
1
3
1
3
Terminal display switches
1
33
t
Debugging information
Figure 2-1 Debugging information outpu
You can use the following commands to operate the two kinds of switches.
Perform the following operations in user view.
Follow these steps to enable debugging and terminal display:
To do… Use the command… Remarks
Enable system
debugging
debugging { all
[ timeout interval ] |
module-name
debugging-option }
By default, all debugging is disabled in
the system.
Because the output of debugging
information will affect the efficiency of the
system, disable your debugging after
you finish it.
Enable terminal
display for
debugging
terminal debugging
By default, terminal display for
debugging is disabled.