H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – System Maintenance and Debugging
H3C S7500 Series Ethernet Switches Chapter 4
Device Management
4-9
To do… Use the command… Remarks
Enter system view
system-view
—
Enable queue traffic
monitoring
qe monitor enable
Required
This function is enabled by
default.
Set the overall traffic
threshold
qe monitor
overflow-threshold
threshold
Optional
300,000,000 bps by default.
4.5.2 Queue Traffic Monitoring Configuration Example
I. Network requirements
z Enable queue traffic monitoring.
z Set the overall traffic threshold used in queue traffic monitoring to 90 Mbps.
II. Configuration procedure
# Enter system view.
<H3C> system-view
[H3C]
# Enable queue traffic monitoring.
[H3C] qe monitor enable
# Set the overall traffic threshold used in queue traffic monitoring to 90 Mbps.
[H3C] qe monitor overflow-threshold 90000000
4.6 Configuring Error Packets Monitoring
If the switch receives a great number of error packets, it will not be able to send/receive
packets properly. With error packets monitoring enabled, the switch collects information
about received error packets regularly. If error packets are detected, it takes protection
measures to ensure that its interfaces send/receive packets properly.
4.6.1 Error Packets Monitoring Configuration Task
The following describes configuration tasks of error packets monitoring.
Follow these steps to configure error packets monitoring:
To do… Use the command… Remarks
Enter the system view
system-view
—
Set the interval for
detecting error packets
qe monitor errpkt
check-time interval
Optional
Defaults to 5 seconds.