H3C S7500 Series Ethernet Switches Operation Manual

Operation Mannual – RRPP
H3C S7500 Series Ethernet Switches Chapter 1
RRPP Configuration
1-8
 Note:
z For information about the chassis, SRPU, and LPU of H3C S7503/S7506/S7506R
series Ethernet switches, refer to H3C S7500 Series Ethernet Switches Installation
Manual.
z For information about the chassis, SRPU, and LPU of H3C S7502 Ethernet switch,
refer to H3C S7502 Ethernet Switch Installation Manual.
As for the above-mentioned ports, to make RRPP-related configuration to take effect,
you need also to make sure that:
z The ports are Trunk ports and permit packets of data VLANs.
z The ports cannot be aggregation ports.
z MSTP, QinQ, 802.1X or Voice VLAN is not enabled on the ports.
1.2 Master Node Configuration
1.2.1 Master Node Configuration Tasks
Follow these steps to configure the master node:
To do… Use the command… Remarks
Enter system view
system-view
—
Create an RRPP
domain, and enter
RRPP domain view
rrpp domain domain-id
Required.
The command prompt of
RRPP domain view
depends on the domain-id
you input.
Specify a control
VLAN for the RRPP
domain
control-vlan vlan-id
Required
Specify the current
switch as the primary
node of a ring, and
specify the primary
port and the
secondary port of the
node
ring ring-id node-mode
master [ primary-port
pri-port ] [ secondary-port
sec-port ] level level-value
Required.
Level 0 identifies the primary
ring and level 1 identifies a
subring.
Configure RRPP
domain timers
timer hello-timer
hello-value fail-timer
fail-value
Optional.
By default, the Hello timer is
set to 1 second, and the Fail
timer to 3 seconds.
Enable an RRPP ring
ring ring-id enable
Required