H3C S7500 Series Ethernet Switches Operation Manual

Operation Mannual – RRPP
H3C S7500 Series Ethernet Switches Chapter 1
RRPP Configuration
1-10
z Define the switch as the master node on primary ring 1 in RRPP domain 1,
GigabitEthernet2/0/1 as the primary port, and GigabitEthernet2/0/2 as the
secondary port.
z Set the Hello timer and Fail time to 2 seconds and 7 seconds respectively.
II. Configuration procedure
<H3C> system-view
[H3C] rrpp domain 1
[H3C-rrpp-domain1] control-vlan 4092
[H3C-rrpp-domain1] ring 1 node-mode master primary-port GigabitEthernet2/0/1
secondary-port GigabitEthernet2/0/2 level 0
[H3C-rrpp-domain1] timer hello-timer 2 fail-timer 7
[H3C-rrpp-domain1] ring 1 enable
[H3C-rrpp-domain-1] quit
[H3C] rrpp enable
[H3C] display rrpp brief
[H3C] display rrpp verbose domain 1
[H3C] display rrpp statistics domain 1
1.3 Transit Node Configuration
1.3.1 Transit Node Configuration Tasks
Follow these steps to configure a transit node:
To do… Use the command… Remarks
Enter system view
system-view
—
Create an RRPP
domain, and enter
RRPP domain view
rrpp domain domain-id
Required.
The command prompt of
RRPP domain view
depends on the domain-id
you input.
Specify a control VLAN
for the RRPP domain
control-vlan vlan-id
Required
Specify the current
switch as the transit
node of a ring, and
specify the primary port
and the secondary port
of the node
ring ring-id node-mode
transit [ primary-port
pri-port ]
[ secondary-port
sec-port ] level
level-value
Required.
Level 0 identifies the primary
ring and level 1 identifies a
subring.
Enable an RRPP ring
ring ring-id enable
Required
Return to system view
quit
—
Enable RRPP
rrpp enable
Required