H3C S7500 Series Ethernet Switches Operation Manual

Operation Mannual – RRPP
H3C S7500 Series Ethernet Switches Chapter 1
RRPP Configuration
1-18
[H3C-rrpp-domain1] ring 1 enable
[H3C-rrpp-domain1] quit
[H3C] rrpp enable
z Configure Switch D
<H3C> system-view
[H3C] rrpp domain 1
[H3C-rrpp-domain1] control-vlan 4092
[H3C-rrpp-domain1] ring 1 node-mode transit primary-port GigabitEthernet2/0/1
secondary-port GigabitEthernet2/0/2 level 0
[H3C-rrpp-domain1] ring 1 enable
[H3C-rrpp-domain1] quit
[H3C] rrpp enable
After the configuration, you can use the display command to view the RRPP
configuration and packet statistics.
1.6.2 Intersectant Ring Network Configuration Example
I. Network requirements
z Switch A, Switch B, Switch C, Switch D, and Switch E constitute RRPP domain 1.
z VLAN 4092 is the control VLAN of RRPP domain 1.
z Switch A, Switch B, Switch C, and Switch D constitute primary ring 1.
z Switch B, Switch C, and Switch E form subring 2.
z Switch A serves as the master node of the primary ring, GigabitEthernet 2/0/1 as
the primary port, and GigabitEthernet 2/0/2 as the secondary port.
z Switch E serves as the master node of the subring, its GigabitEthernet 2/0/1 is the
primary port, and its GigabitEthernet 2/0/2 is the secondary port.
z Switch B serves as a transit node of the primary ring and the edge node of the
subring, its GigabitEthernet 2/0/2 is the common port, and its GigabitEthernet
2/0/3 is the edge port.
z Switch C serves as a transit node of the primary ring and an assistant edge node
of the subring, its GigabitEthernet 2/0/1 is a common port, and its GigabitEthernet
2/0/3 is an edge port.
z Switch D serves as a transit node of the primary ring, its GigabitEthernet 2/0/1 is
the primary port, and its GigabitEthernet 2/0/2 is the secondary port.
z The default values are used for the timer on the primary ring and the subring.