H3C S7500 Series Ethernet Switches Operation Manual

Operation Manual – NAT, Netstream, Policy Routing
H3C S7500 Series Ethernet Switches Chapter 2
Netstream Configuration
2-5
To do… Use the command… Remarks
Enable the aggregation
mode corresponding to
the current aggregation
view
enable
Optional
By default, no aggregation
mode is enabled.
2.2.5 Configuring the Address Information for Netstream Export Packets
After a stream entry is aged out, it is sent to an NSC through Netstream export packet.
Follow these steps to configure the address information of Netstream export packets:
To do… Use the command… Remarks
Enter system view
system-view
—
Global
configuratio
n
ip netstream export
host ip-address udp-port
ip netstream
aggregation { as |
protocol-port |
destination-prefix |
prefix | source-prefix }
Configure
the IP
address
and UDP
port
number of
the
destination
host for
Netstream
export
packets
Configurati
on on a
Netstream
aggregatio
n view
ip netstream export
host ip-address udp-port
Optional
By default,
z In system view, the
destination IP address
is 0.0.0.0 and the
destination port
number is 0.
z The IP address and
port number of the
destination in
aggregation view are
those configured in
system view.
Global
configuratio
n
ip netstream export
source ip-address
ip netstream
aggregation { as |
protocol-port |
destination-prefix |
prefix | source-prefix }
Configure
the source
IP address
of
Netstream
export
packets
Configurati
on on a
Netstream
aggregatio
n view
ip netstream export
source ip-address
Optional
By default, the source IP
address is 0.0.0.0,
indicating that the IP
address of the outbound
interface is used as the
source IP address.
2.2.6 Configuring the Version and AS Option for Netstream Export Packets
Use the ip netstream export version command to configure the version and the AS
option for Netstream export packets. Currently, the switch only supports the
configuration of version 5 and version 9.