H3C S7500 Series Ethernet Switches Release 3135 DHCP Configuration Examples

Routing Configuration Examples
H3C S7500 Series Ethernet Switches Release 3135 Chapter 1 Routing Overview
1-3
1.2.3 RIP Configuration
Table 1-3 RIP configuration task list
Configuration task Remarks
Enabling RIP on an Interface Required
Setting the RIP operating status on an interface Optional
Configuring
basic RIP
functions
Specifying the RIP version on an interface Optional
Setting the additional routing metrics of an
interface
Optional
Configuring RIP route summarization Optional
Disabling the router from receiving host routes Optional
Configuring RIP to filter incoming/outgoing
routes
Optional
Setting RIP preference Optional
Enabling load sharing among RIP interfaces Optional
Configuring RIP
route control
Configuring RIP to redistribute routes from
another protocol
Optional
Configuring RIP timers Optional
Configuring split horizon Optional
Configuring RIP-1 packet zero field check Optional
Setting RIP-2 packet authentication mode Optional
Adjusting and
optimizing a RIP
network
Configuring RIP to unicast RIP packets Optional
I. Enabling RIP on an Interface
Table 1-4 Enable RIP on an interface
Operation Command Remarks
Enter system view
system-view
—
Enable RIP and enter RIP
view
rip
Required
Enable RIP on the
specified interface
network network-address
Required
Disabled by default.