H3C S7500 Series Ethernet Switches Release 3135 DHCP Configuration Examples

Routing Configuration Examples
H3C S7500 Series Ethernet Switches Release 3135 Chapter 1 Routing Overview
1-6
Operation Command Remarks
filter-policy { acl-number |
ip-prefix ip-prefix-name
[ gateway ip-prefix-name ] |
gateway ip-prefix-name }
import [ interface
interface-type
interface-number ]
Configure RIP to
filter incoming routes
filter-policy gateway
ip-prefix-name import
Required
By default, RIP does not
filter any incoming route.
The gateway keyword is
used to filter the incoming
routes advertised from a
specified address.
filter-policy { acl-number |
ip-prefix ip-prefix-name }
export [ protocol [ process-id ] |
interface interface-type
interface-number ]
Configure RIP to
filter outgoing routes
filter-policy route-policy
route-policy-name export
Required
By default, RIP does not
filter any outgoing route.
VIII. Setting RIP preference
Table 1-11 Set RIP preference
Operation Command Remarks
Enter system view
system-view
—
Enter RIP view
rip
—
Set the RIP preference
preference value
Required
The default RIP preference is 100.
IX. Enabling load sharing among RIP interfaces
Table 1-12 Enable load sharing among RIP interfaces
Operation Command Remarks
Enter system view
system-view
—
Enter RIP view
rip
—
Enable load sharing
among RIP interfaces
traffic-share-across-inte
rface
Required
By default, load sharing
among RIP interfaces is
disabled