H3C S7500 Series Ethernet Switches Release 3135 DHCP Configuration Examples

Routing Configuration Examples
H3C S7500 Series Ethernet Switches Release 3135 Chapter 1 Routing Overview
1-8
XIII. Configuring RIP-1 packet zero field check
Table 1-16 Configure RIP-1 packet zero field check
Operation Command Remarks
Enter system view
system-view
—
Enter RIP view
rip
—
Enable the check of the
“must be zero” field in
RIP-1 packets
checkzero
Required
Enabled by default.
XIV. Setting RIP-2 packet authentication mode
Table 1-17 Set RIP-2 packet authentication mode
Operation Command Remarks
Enter system view
system-view
—
Enter interface
view
interface
interface-type
interface-number
—
Set RIP-2 packet
authentication
mode
rip
authentication-mo
de { simple
password | md5
{ rfc2453 key-string
| rfc2082 key-string
key-id } }
Required
If you specify to use MD5
authentication, you must specify one of
the following MD5 authentication types:
z rfc2453 (this type supports the
packet format defined in RFC 2453)
z rfc2082 (this type supports the
packet format defined in RFC 2082)
XV. Configuring RIP to unicast RIP packets
Table 1-18 Configure RIP to unicast RIP packets
Operation Command Remarks
Enter system view
system-view
—
Enter RIP view
rip
—
Configure RIP to unicast
RIP packets
peer ip-address
Required
When RIP runs on the link that does
not support broadcast or multicast,
you must configure RIP to unicast
RIP packets.