H3C S7500 Series Ethernet Switches Release 3135 DHCP Configuration Examples

Routing Configuration Examples
H3C S7500 Series Ethernet Switches Release 3135 Chapter 1 Routing Overview
1-17
Operation Command Remarks
Configure the
authentication mode of
the OSPF interface
ospf
authentication-mode
{ simple password | md5
key-id key }
Optional
By default, OSPF packets
are not authenticated on
an interface.
XVI. Configuring the MTU Field in DD Packets
Table 1-36 Configure to fill the MTU field when an interface transmits DD packets
Operation Command Remarks
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
Required
Enable the interface to fill
in the MTU field when
transmitting DD packets
ospf mtu-enable
Optional
By default, the MTU value
is 0 when an interface
transmits DD packets.
That is, the actual MTU
value of the interface is
not filled in.
XVII. Configuring OSPF Network Management
Table 1-37 Configure OSPF network management (NM)
Operation Command Remarks
Enter system view
system-view
—
Configure OSPF MIB
binding
ospf mib-binding process-id
Optional
By default, OSPF MIB is
bound to the first enabled
OSPF process.
Enable OSPF Trap
sending
snmp-agent trap enable
ospf [ process-id ] [ ifauthfail |
ifcfgerror | ifrxbadpkt |
ifstatechange |
iftxretransmit |
lsdbapproachoverflow |
lsdboverflow | maxagelsa |
nbrstatechange |
originatelsa | vifauthfail |
vifcfgerror | virifrxbadpkt |
virifstatechange |
viriftxretransmit |
virnbrstatechange ]*
Optional
You can configure OSPF
to send diversified SNMP
TRAP messages and
specify a certain OSPF
process to send SNMP
TRAP messages by
process ID.