H3C S7500 Series Ethernet Switches Release 3135 DHCP Configuration Examples

Multicast Protocol Configuration Examples
H3C S7500 Series Ethernet Switches Release 3135 Chapter 1 Multicast Protocol Overview
1-12
To do... Use the command... Remarks
Configure a C-BSR
c-bsr interface-type
interface-number
hash-mask-len [ priority ]
Optional
By default, no C-BSR is
configured. The default
priority is 0.
Configure a C-RP
c-rp interface-type
interface-number
[ group-policy
acl-number | priority
priority ]*
Optional
By default, no C-RP is
configured. The default
priority is 0.
Configure a static RP
static-rp rp-address
[ acl-number ]
[ preferred ]
Optional
No static RP is configured
by default.
If you configure a static
RP while a dynamic RP
exists, the preferred
keyword makes the static
RP the preferred RP; if
you do not use the
preferred keyword in this
command, the dynamic
RP is given preference,
Configure a legal BSR
address range
bsr-policy acl-number
Optional
No legal BSR address
range is configured by
default.
Configure a legal C-RP
address range
crp-policy acl-number
Optional
You can define the related
IP address ranges in an
ACL.
No legal C-RP address
range is configured by
default.
Configure to filter the
register messages from
RP to DR
register-policy
acl-number
Optional
You can define the related
IP addresses in an ACL.
Disabled by default.
Disable RPT-to-SPT
switchover
spt-switch-threshold
{ traffic-rate | infinity }
[ group-policy
acl-number [ order
order-value ] ]
Optional
By default, the device
switches to the SPT
immediately after it
receives the first multicast
packet from the RPT.
Enter VLAN interface view
interface Vlan-interface
interface-number
—
Enable PIM-SM
pim sm
Required