H3C S7500E Series Ethernet Switches Command Manual

Command Manual – IP Routing Overview
H3C S7500E Series Ethernet Switches Chapter 1 Routing Overview Commands
1-7
Field Description
Route status:
Active This is an active unicast route.
Adv This route can be advertised.
Delete This route is deleted.
Gateway This is an indirect route.
Holddown
Number of holddown routes. Holddown is a route
advertisement policy used in some distance vector
(D-V) routing protocols, such as RIP, to avoid the
propagation of some incorrect routes. It distributes
a Holddown route during a period regardless of
whether a new route to the same destination is
found. For details, refer to corresponding routing
protocols.
Int
The route was discovered by an Internal Gateway
Protocol (IGP).
NoAdv
The route is not advertised when the router
advertises routes based on policies.
NotInstall
Normally, among routes to a destination, the route
with the highest preference is installed into the
core routing table and advertised, while a
NotInstall route cannot be installed into the core
routing table but may be advertised.
Reject
The packets matching a Reject route will be
dropped. Besides, the router sends ICMP
unreachable messages to the sources of the
dropped packets. The Reject routes are usually
used for network testing.
Static
A static route is not lost when you perform the save
operation and then restart the router. Routes
configured manually are marked as static.
Unicast Unicast routes
Inactive Inactive routes
Invalid Invalid routes
WaitQ The route is the WaitQ during route recursion.
TunE Tunnel
State
GotQ The route is in the GotQ during route recursion.
Age
Time for which the route has been in the routing table, in the
sequence of hour, minute, and second from left to right.
Tag Route tag