H3C S7500E Series Ethernet Switches Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 5 MSDP Configuration Commands
5-3
Field Description
Up/Down time
Length of time since MSDP peer connection was
established/failed
AS
Number of the AS where the MSDP peer is located. “?”
indicates that the system was unable to obtain the AS
number.
SA Count Number of (S, G) entries
Reset Count MSDP peer connection reset times
5.1.3 display msdp peer-status
Syntax
display msdp peer-status [ peer-address ]
View
Any view
Parameters
peer-address: Specifies an MSDP peer by its address. If you do not provide this
argument, this command will display the detailed status information of all MSDP peers.
Description
Use the display msdp peer-status command to view the detailed MSDP peer status
information.
Related commands: peer connect-interface, peer description, peer mesh-group,
peer minimum-ttl, peer request-sa-enable, peer sa-cache-maximum, peer
sa-policy, peer sa-request-policy.
Examples
# View the detailed status information of the MSDP peer with the address of
10.110.11.11.
<Sysname> display msdp peer-status 10.110.11.11
MSDP Peer 20.20.20.20, AS 100
Description:
Information about connection status:
State: Up
Up/down time: 14:41:08
Resets: 0
Connection interface: LoopBack0 (20.20.20.30)
Number of sent/received messages: 867/947