H3C S7500E Series Ethernet Switches Installation Manual

Installation Manual
H3C S7500E Series Ethernet Switches Chapter 3 Hardware Installation
3-7
Figure 3-8 Connect the AC power cable for the PSR320-A (II)
To connect the AC power cable for the PSR320-A, proceed as follows:
1) Plug one end of the AC power cable into the socket on the switch and lock the
cable with the power cable retainer.
2) Plug the other end into the AC power socket strip, which is connected to the AC
power supply in the equipment room.
II. PSR650-A power module
Refer to section 3.6.1 I. “PSR320-A power module” on page 3-6.
III. PSR1400-A power module
Figure 3-9 Connect the AC power cable for the PSR1400-A
To connect the AC power cable for the PSR1400-A, proceed as follows:
1) Use a Phillips screwdriver to screw off the right part of the power cable retainer
suite.
2) Plug one end of the power cable shipped with the switch into the power socket and
fasten the left part of the power socket retainer suite to the other part to lock the
power cable.