H3C S7500E Series Ethernet Switches Installation Manual

Installation Manual
H3C S7500E Series Ethernet Switches Chapter 5 Hardware Maintenance
5-13
 Note:
If you want to use the CF card after you execute the umount command, you can
execute the mount command in user view to mount the CF card again.
For detailed descriptions about the mount and umount commands, refer to the file
system management commands in S7500E Series Ethernet Switches Command
Manual.
2) Press down the eject button and remove the CF card when it is ejected part way
out of the slot. (See
Figure 5-13.)
Figure 5-13 Remove the CF card
Caution:
To avoid damaging the hardware or the file system on the CF card, do not remove the
CF card when the switch is booting or the CFS LED is flashing.
Put the removed CF card in an antistatic bag to protect it against ESD damage.