H3C S7500E Series Ethernet Switches Installation Manual

Installation Manual
H3C S7500E Series Ethernet Switches Chapter 1 Product Overview
1-29
II. Technical specifications
Table 1-33 Technical specifications of the LSQ1SRP2XB0
Item Specifications
CPU MIPS64, 600 MHz
Boot ROM 512 KB
Flash memory 64 MB
DDR SDRAM 512 MB
Dimensions (H × W × D) 45 × 377 × 355 mm (1.77 × 14.84 × 13.98 in.)
Interfaces
z One CF card interface
z Two 10GBase-R-XFP Ethernet ports
z One console port, used for local or remote
configuration and management of the switch through
a dialup connection
z One 10/100Base-TX management Ethernet port
Power consumption 55 W to 65 W
III. Panel and LEDs
Figure 1-20 shows the front panel of the LSQ1SRP2XB0.
(1) CF card slot and CFS LED (2) 10GBase-R-XFP Ethernet ports and LEDs
(3) Console port
(4) 10/100Base-TX Ethernet port for management and LEDs
(5) Power and fan tray status LEDs (6) LPU status LEDs
(7) ACTIVE LED of LSQ1SRP2XB0 (8) RESET button
Figure 1-20 Front panel of the LSQ1SRP2XB0
IV. On-board interfaces
z CF card slot
The CF card slot can accommodate a standard CF card (Type I or Type II), where you
can store host software and logs, and thus upgrade software conveniently. The CF card
is hot swappable.
Table 1-34 describes the CFS LED on the right of the CF card.