H3C S7500E Series Ethernet Switches Installation Manual

Installation Manual
H3C S7500E Series Ethernet Switches Chapter 1 Product Overview
1-45
III. Panel and LEDs
Figure 1-24 shows the front panel of the LSQ1SRPD0.
(1) CF card slot and CF card status LED (2) Console port
(3) 10/100Base-TX management Ethernet port and
LEDs
(4)Power module and fan status LEDs
(5) LPU status LEDs (6) ACTIVE LED of LSQ1SRPD0
(7) RESET button
Figure 1-24 Front panel of the LSQ1SRPD0
IV. On-board interfaces
z CF card slot
The CF card slot can accommodate a standard CF card (Type I or Type II), where you
can store host software and logs and thus upgrade software conveniently. The CF card
is hot swappable.
z Console port
Using an RJ-45 connector, the console port can be connected through a regular
asynchronous serial cable directly to a computer for system debugging, configuration,
maintenance, management, and host software loading, or to a modem for remote
system debugging, configuration, maintenance and management.
Table 1-67 Specifications of the console port
Item Specifications
Connector type RJ-45
Number of connectors 1
Interface standard Asynchronous EIA/TIA-232
Baud rate 115,200 bps (defaulting to 9,600 bps)
Transmission distance 15 m (49.21 ft.)
Functions
z It can be connected to an ASCII terminal.
z It can be connected to a serial port of a local or
remote (through a pair of modems) PC running
terminal emulation program.
z 10/100Base-TX management Ethernet port
Using an RJ-45 connector, the 10/100Base-TX management Ethernet port can be
connected to a local PC for switch program loading and switch debugging, or
connected to a remote NMS for remote management.