H3C S7500E Series Ethernet Switches Installation Manual

Installation Manual
H3C S7500E Series Ethernet Switches Chapter 2 Installation Preparations
2-6
2.4 Installation Tools
Table 2-4 Required installation tools list
Type Name Tools
Measure and
lineation tools
Long tape, ruler (of 1 meter), gradienter, marking
pen, powder marker and pencil
Drills
A percussion drill, several auxiliary drill bits, a
vacuum cleaner
Fastening tools
Flat-blade screwdriver P4-75mm
Phillips screwdriver P1-100mm, P2-150mm and
P3-250mm
Socket wrench M5
Socket wrench M6
Double offset ring wrench M6
Double-ended double offset ring wrench (10-12)
or double open-end wrench (10-12)
Small tools
Sharp-nose pliers, diagonal pliers, vices,
hand-held electrical drill, file, handsaw, crowbar
and rubber hammer
General tools
Auxiliary tools
Hair brush, tweezers, paper knife, hand bellows,
electric iron, solder wire, fork and ladder
Special tools
ESD-preventive wrist glove, cable stripper, crimping pliers, RJ-45
crimping pliers and wire punchdown tool
Tools for
fiber-optic
cleaning
Lint-free paper, and optical fiber End-Face microscope
Instruments
Multimeter, 500 V Meg-ohmmeter (used to measure the insulation
resistance), error detector, optical power meter and earth
resistance tester
 Note:
The above instruments and tools are not shipped with the S7500E series and need to
be prepared by the users.