H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – Port Mirroring
H3C S7500E Series Ethernet Switches Chapter 1 Port Mirroring Configuration
1-4
 Note:
z A local mirroring group is effective only when it has both source ports and the
destination port configured.
z It is not recommended to enable STP, RSTP or MSTP on the destination port;
otherwise, the mirroring function may be affected.
z Do not use the destination mirroring port for any purpose other than port mirroring.
z The source ports and the destination port cannot be the member ports of the current
mirroring group.
z Before adding the destination port for a port mirroring group, make sure the port
mirroring group exists. A mirroring group can have only one destination port.
1.3 Configuring Remote Port Mirroring
1.3.1 Configuring a Remote Source Mirroring Group
Follow these steps to configure a remote port mirroring group
To do… Use the command… Remarks
Enter system view
system-view
—
Create a remote
source mirroring group
mirroring-group group-id
remote-source
Required
In system
view
mirroring-group group-id
mirroring-port mirroring-port-list
{ both | inbound | outbound }
interface interface-type
interface-number
[ mirroring-group group-id ]
mirroring-port { both | inbound |
outbound }
Add ports
to the
mirroring
group as
source
ports
In
interface
view
quit
Use either
approach.
You can add ports
to a source port
mirroring group in
either system view
or interface view.
They achieve the
same purpose.
In system
view
mirroring-group group-id
monitor-egress
monitor-egress-port-id
interface interface-type
interface-number
mirroring-group group-id
monitor-egress
Add a
port to
the
mirroring
group as
the
outbound
mirroring
port
In
interface
view
quit
Use either
approach.
You can add ports
to a source
mirroring group in
either system view
or interface view.
They achieve the
same purpose.