H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – SNMP-RMON
H3C S7500E Series Ethernet Switches Chapter 1 SNMP Configuration
1-11
 Note:
The configurations on the agent and the NMS must match.
1.7 SNMP Logging Configuration Example
I. Network requirements
z NMS and Agent are connected through an Ethernet
z The IP address of NMS is 1.1.1.2/24
z The IP address of the VLAN interface on Agent is 1.1.1.1/24
z Configure community name, access right and SNMP version on Agent
II. Network diagram
Figure 1-4 Network diagram for SNMP logging
III. Configuration procedure
 Note:
The configurations for NMS and Agent are omitted.
# Enable logging display on the terminal (optional, enabled by default).
<Sysname> terminal monitor
<Sysname> terminal logging
# Enable the information center to output the system information with the severity of
informational to the Console port.
<Sysname> system-view
[Sysname] info-center source snmp channel console log level informational
# Enable SNMP logging on Agent to log the GET and SET operations of NMS.
[Sysname] snmp-agent log get-operation
[Sysname] snmp-agent log set-operation