H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – File System Management
H3C S7500E Series Ethernet Switches Chapter 1 File System Management Configuration
1-10
 Note:
If you specify the file-name argument when executing the save command, the system
saves the current configuration with specified path; if you do not specify the file-name
argument and enable the configuration file saving synchronization function, the system
automatically saves the current configuration to the SMB.
1.2.4 Erasing the Startup Configuration File
With the configuration file erased, your device will boot up with the default configuration
next time it is powered on.
You may need to erase the configuration file for one of these reasons:
z After you upgrade software, the original configuration file does not match the new
software.
z The startup configuration file is corrupted or not the one you need.
Follow the step below to erase the configuration file:
To do… Use the command… Remarks
Erase the startup
configuration file from the
storage device
reset
saved-configuration
Required
Available in user view
Caution:
This command will permanently delete the configuration file from the device. Use it with
caution.
1.2.5 Specifying a Configuration File for Next Startup
Follow the step below to specify a configuration file for next startup:
To do… Use the command… Remarks
Specify a configuration file
for next startup
startup
saved-configuration
cfgfile
Required
Available in user view