H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – File System Management
H3C S7500E Series Ethernet Switches Chapter 1 File System Management Configuration
1-12
 Note:
Before backup, you should:
z Ensure that the server is reachable, the server is enabled with TFTP service, and
the client has permission to read and write.
z Use the display startup command (in user view) to verify if you have set the startup
configuration file, and use the dir command to verify if this file exists. If the file is set
as NULL or does not exist, the backup will be unsuccessful.
III. Restoring the startup configuration file
To do… Use the command… Remarks
Restore the startup
configuration file
restore
startup-configuration
from src-addr filename
Required
Available in user view
 Note:
z Before restoring a configuration file, you should ensure that the server is reachable,
the server is enabled with TFTP service, and the client has permission to read and
write.
z After the command is successfully executed, you can use the display startup
command (in user view) to verify if the filename of the startup configuration file is the
same with the filename argument, and use the dir command to verify if the restored
file exists.
1.3 Displaying and Maintaining Device Configuration
To do… Use the command… Remarks
Display the configuration
file saved in the storage
device
display saved-configuration
[ by-linenum ]
Available in any view
Display the configuration
file used for this and next
startup
display startup
Available in any view
Display the validated
configuration in current
view
display this [ by-linenum ] Available in any view