H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – File System Management
H3C S7500E Series Ethernet Switches Chapter 3 TFTP Configuration
3-3
z If the source address is specified with the tftp client source command and then
with the tftp command, the source address configured with the latter one is used
to communicate with a TFTP server.
The source address specified with the tftp client source command is valid for all tftp
connections and the source address specified with the tftp command is valid only for
the current tftp connection.
Follow these steps to configure the TFTP client:
To do… Use the command… Remarks
Enter system view
system-view
—
Reference an access
control list (ACL) to the
TFTP server
tftp-server [ ipv6 ] acl
acl-number
Optional
Configure the source
address of the TFTP client
tftp client source
{ interface interface-type
interface-number | ip
source-ip-address }
Optional
A device uses the source
address determined by
the routing protocol to
communicate with the
TFTP server by default.
Return to user view
quit
—
Download or upload a file
in IPv4 network
tftp server-address { get |
put | sget }
source-filename
[ destination-filename ]
[ source { interface
interface-type
interface-number | ip
source-ip-address } ]
Optional
Download or upload a file
in IPv6 network
tftp ipv6 tftp-ipv6-server
[ -i interface-type
interface-number ] { get |
put } source-file
[ destination-file ]
Optional
 Note:
z If no primary IP address is configured on the source interface, TFTP connection
fails.
z If you use the ftp client source command to first configure the source interface and
then the source IP address of the packets of the TFTP client, the new source IP
address will overwrite the current one, and vice versa.