H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – Information Center
H3C S7500E Series Ethernet Switches Chapter 1 Information Center Configuration
1-3
Information
channel number
Default channel
name
Default output destination
4 logbuffer
Log buffer (Receives log information, a
buffer inside the router for recording
information.)
5 snmpagent SNMP NMS (Receives trap information)
6 channel6
Not specified (Receives log, trap, and
debugging information)
7 channel7
Not specified (Receives log, trap, and
debugging information)
8 channel8
Not specified (Receives log, trap, and
debugging information)
9 channel9
Log file (Receives log, trap, and debugging
information)
 Note:
Configurations for the seven output destinations function independently and take effect
only after the information center is enabled.
IV. Outputting system information by source module
The system is composed of a variety of protocol modules, board drivers, and
configuration modules. The system information can be classified, filtered, and output by
source module. Some source module names and descriptions are shown in
Table 1-3.
Table 1-3 Source module list
Module name Description
8021X 802.1X module
ACL Access Control List module
ARP Address Resolution Protocol module
BGP Border Gateway Protocol module
CFM Configuration File Management module
CMD Command line module
default Default setting of all modules
DEV Device management module
DHCP Dynamic Host Configuration Protocol module
DNS Domain Name System module