H3C S7500E Series Ethernet Switches Operation Manual

Operation Manual – VLAN
H3C S7500E Series Ethernet Switches Chapter 4 GVRP Configuration
4-5
4.2 Configuring GVRP
 Note:
GVRP can only be configured on trunk ports.
Complete the following tasks to configure GVRP:
Task Remarks
Enabling GVRP Required
Configuring GARP Timers Optional
4.2.1 Enabling GVRP
Follow these steps to enable GVRP on a trunk port:
To do… Use the command… Remarks
Enter system view
system-view
––
Enable GVRP globally
gvrp
Required
Globally disabled by
default
Enter
Ethernet
port view
interface interface-type
interface-number
Enter
Ethernet
port view
or
port-group
view
Enter
port-group
view
port-group { aggregation
agg-id | manual
port-group-name }
Required
Perform either of the
operations.
Depending on the view
you accessed, the
subsequent configuration
takes effect on a port or all
ports in a port-group.
Enable GVRP on the
port
gvrp
Required
Disabled by default
Configure the GVRP
registration mode on
the port
gvrp registration { fixed |
forbidden | normal }
Optional
The default is normal.
 Note:
Because GVRP is not compatible with the BPDU tunneling feature, you must disable
BPDU tunneling before enabling GVRP on a BPDU tunneling-enabled Ethernet port.